Installation; Electrical Connection; Description Of The Hood - Elica LIB0107306 Montage- Und Gebrauchsanweisung

Use
The hood has been made for use in the internal recirculating
filtering version.
Cooking fumes and steam are aspirated inside the hood,
filtered and cleaned, passing through the fat filter/s and the
carbon filter/s that MUST be supplied with the hood.
Attention! If the hood is not supplied with carbon filter,
then it must be ordered and mounted.

Installation

Specialised personnel must carry out both the electrical
and the mechanical installation.
The minimum distance between the supporting surface for the
cooking equipment on the hob and the lowest part of the
range hood must be not less than 50cm from electric cookers
and 65cm from gas or mixed cookers.
If the instructions for installation for the gas hob specify a
greater distance, this must be adhered to.

Electrical connection

The mains tension must correspond to the tension shown on
the characteristic label situated inside the hood.
The product is meant for connecting directly to the mains
supply, therefore apply a regulation bipolar switch that
ensures complete disconnection from the mains in the
conditions of category III over-tension, conforming to the
installation rules.
Warning! Detail B (fixing bracket to the ceiling - Fig. 1) is
equipped with a conductor (yellow-green) that must be
connected to the earth of the domestic electrical plant.
Fig. 4
Warining! Changing the interconnection cable must be
carried out by the authorised technical assistance service.
Mounting
Expansion wall plugs are provided to secure the hood to most
types of walls/ceilings. However, a qualified technician must
verify suitability of the materials in accordance with the type of
wall/ceiling. The wall/ceiling must be strong enough to take
the weight of the hood. Do not tile, grout or silicone this
appliance to the wall. Surface mounting only.

Description of the hood

Fig. 1
A. Dowels for fixing the support bracket
B. Support to the ceiling bracket
C. Screws for fixing the support bracket
D. Regulators of the tie-rods of the hood
E. Decorative cover
F. Box for connecting to the domestic power network
G. Cable block
H. Interconnection cable
I. Lateral moulding
J. Suction hood
K. Control lever
Attention! The control lever is already supplied. It is to
be installed last, before connecting the hood to the
mains.
Insert the control lever into the apposite housing (see
drawings on the first pages of this booklet - triggered
connection, compulsory direction.
L. Halogen bulb
M. Lateral filter holder frame
N. Active carbon filter
O. Metal anti-fat filter
Note: other carbon and anti-fat filters are installed inside
the hood in correspondence with the shaped lateral slots
and the upper part of the hood (see also Figs. 11-a-b-c-d-
e-f-g-h)
P. Anti-fat and carbon filters holder frame
Q. Filter holder frame releases
R. Screws for fixing the cable block and the cover of the
connections box
S. Screws for fixing the connections box to the support
bracket
T. Tie-rod blocks
U. Tie-rods
V. Tie-rod connection brackets
W. Screws for fixing the tie-rod connection brackets
X. Screws for fixing the bracket cover
Y. Fixing template.
15