Accessories - Hettich BLUE MAX miniTyp 2/6 Betriebsanleitung

2.2.3 Drill bits
The machine is designed for the use of tungsten carbide tipped drill
bits, 57 mm long, centre point, 10 mm shank diameter (with clam-
ping surface). Push drill bits in as far as they will go, with clamping
surface turned towards the grub screws. Tighten by means of Allen
key (2.5 A/F). Note direction of spindle rotation.
If necessary adjust the length of the drill bits at the adjustment
screws in the drill shank.
2.3 Connecting
2.3.1 Connection
Connect device to the electrical power supply. Please also refer to
Section 8.2 (Technical specifications, "Electrical system") in this
context.

2.4 Accessories

2.4.1 Fence extension
(order no. 020 485)
Push half of angle guide (1) onto fence extension and half onto
fence, and secure with screws and clamping blocks (2)
2.4.2 Support saddle
(order no. 020 486)
The support saddle is used for supporting the extended fence as well
as a wider work top. For this purpose, fix extended fence to the
angle guide angle using clamping blocks and machine screw. Slide
work top onto profile by means of collar screws.
©
©
19
GB GB