Octagon SF208 E2 HD LCD Single Bedienungsanleitung Seite 51

Amongst other things, the below parameters are what you need to decide prior to performing
manual scan.
① Tuner
You need to decide which tuner you want to use for manual scan.
② System
Here you have two options between DVB-S(SD) and DVB-S2(HD).
③ Frequency
You need to enter the exact frequency of the transponder that you want to scan.
④ Symbol Rate
You need to enter the exact symbol rate of the transponder that you want to scan.
⑤ Polarity
Here, you have options for Horizontal, Vertical, Circular Left and Circular Right. You need to
know the polarity of the transponder that you want to scan.
⑥ FEC (Forward Error Correction)
You need to enter the exact FEC value of the transponder that you want to scan.
⑦ Modulation
Here you have two options for QPSK (SD) and 8PSK (HD).
⑧ Network Scan
Here you have two options for YES and NO. NO is used to scan the transponder (TP) based
on the data that your receiver currently has. YES is used to scan the TP not just based on the
existing TP data but also using new TP data, if there is TP data newly transported from the TP.
Naturally, YES option takes longer while it may results in a better scan result.
⑨ Clear Before Scan
YES is used when you want to delete the existing channel list before you start the automatic
scan. If you want to keep the existing list, select NO .
⑩ Only Free Scan
Here you have two options for YES and NO . You want to scan only Free to Air channels without
any encryption, select YES. Otherwise, select NO to scan all FTA and CAS channels.
Press OK to activate the manual scan. This will take some minutes. As the scan proceeds, you
will see the progressive bar and the newly found services underneath.
SF208 E2 HD LCD Single
Bedienungsanleitungen / User Manual
50