Operation; Preparation; Brewing Coffee - Beko CFM6201W Benutzerhandbuch

3

Operation

3.1 Preparation

A
WARNING: First time use: Run
the appliance at least 4 times
without adding coffee.
A
WARNING: Please follow the
steps 1 - 2 and 7 - 12 in the "Brewing
Coffee" section.
1. Remove all packaging and stickers and
dispose of them according to applicable legal
regulations.
2. Before using the appliance for the first time,
clean all parts which come into contact with
water carefully. Please see full details in the
"Cleaning and Care" section.
3. Make sure that the appliance is placed in an
upright position and on a stable, flat, clean, dry,
and non-slip surface.

3.2 Brewing Coffee

1. There are two ways to fill water. In the first
way, water can be filled by taking the water
compartment out and opening the cover
located on it. In the second way, water can filled
through the water intake section on the cover
without taking the water compartment out.
However, do not exceed the marking "10". Pull
off and fill the water tank (6) with the required
amount of water, but do not fill past the "10"
mark. The brewed amount of coffee will be 10%
less than the filled water, because it is absorbed
by the coffee grounds and the filter. For the
good coffee taste it is suggested to operate the
appliance with at least 4 cups coffee serving.
For improved heat retention we
C
recommend that you rinse the pot
with hot water before starting the
brewing process.
C
Use only clean, cold, and fresh
drinking water.
Coffee Maker / User Manual
There is a drip hole on the back
of the water reservoir to prevent
C
exceeding the capacity of the coffee
maker. If you add too much water,
it will drip out from the back of the
appliance.
2. Close the water tank cover (1) and open the
filter basket cover (2).
3. Pull out the filter basket (3).
4. Take a suitable paper filter (1 x 4) and insert the
paper filter into the filter basket (3).
C
Use only one paper filter at each
time. Make sure that the paper filter
does not bend or fold.
5. Fill the filter with the desired amount of ground
coffee. To do this, you may use the supplied
measuring spoon.
6. Insert the filter basket (3) back into the housing
and close the filter basket cover (2).
7. Place the thermo jug (10) on the support for
thermo jug (11).
WARNING: If the filter basket (3)
is not closed or the thermo jug (10)
A
is not placed accurately, the drip-
stop (9) function will not function
properly. It could cause hot water or
hot coffee to overflow.
8. Connect the plug to the wall socket.
9. Turn the appliance on by pushing the On/Off
button (8).
– The On/Off button (8) illuminates and the
brewing process begins.
C
The brewing process can be stopped
at any time by pushing the On/Off
button (8) again.
9 / 95 EN