Start Up; Simple Operating Functions On The Device; Teaching-In - HomeMatic HM-LC-Sw4-SM Bedienungsanleitung

7

Start up

7.1 Simple operating functions on the
device
There is one control button per channel on the
devices (one UP button and one DOWN button for
the blind actuator). You can operate the actuator
immediately (teaching is not required) and check
for correct electrical installation. With switching
and dimming actuators, you can use it to switch the
channel on and off. With blind actuators, you can
move the hangings up or down.
Only the brief button press is used for
operation. The longer button press (holding
longer than 4 seconds) switches the actuator to
teach mode.

7.2 Teaching-in

Please read this section completely before starting
teaching-in!
Teaching-in requires that both devices to be
connected are put into teach mode and the desired
channel must be selected for training.
54