Technical Data; Declaration Of Conformity; Noise/Vibration Information; Mounting And Operation - Bosch GWS Professional 9-115 Originalbetriebsanleitung

16 | English

Technical Data

The technical data of the machine are listed in the table on
page 255–256.
The values given are valid for a nominal voltage [U] of 230 V.
For different voltages and models for specific countries,
these values can vary.
Please observe the article number on the type plate of your
machine. The trade names of the individual machines may
vary.

Declaration of Conformity

We declare under our sole responsibility that the product de-
scribed under "Technical Data" is in conformity with all rele-
vant provisions of the directives 2011/65/EU, 2014/30/EU,
2006/42/EC including their amendments and complies with
the following standards: EN 60745-1, EN 60745-2-3.
Technical file (2006/42/EC) at:
Robert Bosch GmbH, PT/ETM9,
70764 Leinfelden-Echterdingen, GERMANY
Henk Becker
Executive Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
70764 Leinfelden-Echterdingen, GERMANY
Leinfelden, 14.07.2014

Mounting and Operation

The following table indicates the action objectives for mounting and operation of the power tool. The instructions for each action
objective are shown aside. Depending on the type of application, various instruction combinations are required. Observe the
safety instructions.
Action
Grinding, preparation
Cutting, preparation
Cutting stone, brick and tiles,
preparation (recommendation)
1 609 92A 0Y9 | (1.8.14)
Helmut Heinzelmann
Head of Product Certification
PT/ETM9
30°

Noise/Vibration Information

The measured values of the machine are listed in the table on
page 255–256.
Sound emission values determined according to
EN 60745-2-3.
Vibration total values a (triax vector sum) and uncertainty K
h
determined according to EN 60745.
The vibration level given in this information sheet has been
measured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with anoth-
er. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main ap-
plications of the tool. However if the tool is used for different
applications, with different accessories or insertion tools or is
poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibration should also
take into account the times when the tool is switched off or
when it is running but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total working
period.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and the
accessories, keep the hands warm, organisation of work pat-
terns.
Figure Please observe
1
2
3
Page
257 – 258
259 – 260
261 – 262
Bosch Power Tools