Carrera RC 370503016 Montage- Und Betriebsanleitung Seite 21

Checklist for flight preparation
This checklist is not a substitute for the con-
tents of the operating instructions. Although it
can be used as a quick-start-guide, we strong-
ly recommend you first to read the operating
instructions in detail before you proceed.
• Check the contents of the package.
• Connect the charging unit to the source of
power.
• Charge the lipo-battery as described in the
section "Recharging the LiPo rechargeable
battery".
• Fit 2 AA batteries in the controller, making
sure their polarity is correct.
• Look for a suitable environment for flying.
• Read and comply with the legal and safe-
ty regulations governing the use of your
Quadrocopters.
• Slide the battery into the battery bay on the
bottom of the Quadrocopter.
• Connect the battery in the model.
• WARNING! Immediately after switching it
on, place the Quadrocopter on a flat and
level surface. The gyro-system will then
set itself automatically.
• The LEDs on the quadrocopter flash.
• Switch on the controller at the ON/OFF
switch. Be sure to check the Beginner-Ad-
vanced switch (
joystick, i.e., the throttle control, completely
upwards and then completely downwards.
• Allow the Quadrocopter a few moments un-
til the system is correctly initialised and is
ready for operation. The LED in the Quadro-
copter now lights continuously. The LED on
the controller now lights continuously.
• Repeat the above points as required, if you
wish to fly more Quadrocopters at the same
time.
• Important note! Please perform the au-
to-trimming before each flight!
17
• Press the 'Start rotors' button.
• Check the control system.
• Make yourself familiar with the control system.
• Trim the Quadrocopter as necessary as
described under
hovering it no longer moves from the spot
2b
). Push the left-hand
13c
, so that when
17 18 19 20
without a command from the controller.
• The Quadrocopter is now ready to be flown.
• If the Quadrocopter displays no functions,
retry the above binding procedure.
• Fly the model.
• Land the model.
• Disconnect the battery plug connection.
• Always switch off the remote control last.
Flying the 4-channel Quadrocopter
NOTE!
Take care particularly in the first few
flights to move the lever on the control-
ler very gently and not over-hurriedly. As
a rule, only very small movements of the
respective levers are necessary to carry
out the desired control commands!
If you notice that the Quadrocopter moves
forwards or to the side without your touching
the respective lever, please adjust the trim of
the Quadrocopter as described in
+/- Gas (up / down)
9
To start or to fly higher, push the gas le-
ver on the left cautiously forwards. To land
or fly lower, push the gas lever on the left
cautiously backwards.
10
To make the Quadrocopter circle to the left
or the right on the spot, move the lever on
the left cautiously to the left or the right.
11
To fly the Quadrocopter to the left or the
right, push the lever on the right cautiously
to the left or the right.
12
To fly the Quadrocopter forwards or back-
wards, push the lever on the right cautious-
ly forwards or backwards.
Start the rotors and motors
13 a Press the 'Start rotors' button on the
controller, in order to start the motors.
You can lift the throttle control upwards as
soon as the rotors are running.
21
ENGLISH
17 18 19 20
.