Miditech i2 Control-37 black edition Bedienungsanleitung Seite 8

Control Change data entry by Numeric keypad
The i² Control-37 black edition allows you to use the numeric keys to specify your
Control Change DATA parameter instead of the DATA ENTRY knob. By pressing
MIDI SELECT button and CC DATA key & then the required number and finally the
Enter key to finish. For example, if you want to make Control Change 7 as value
123.
1) Press MIDI SELECT knob;
2) press CC No.(will be shown in display)
3) choose 7 on numeric keypad;
4) press enter key to specify Control Change as 7;
5) the display shows "---"
6) press CC DATA.(will be shown in display)
7) Press number key 1, 2, and 3, then press enter key to specify value 123 then
press MIDI SELECT knob to finish this action.
9) For Velocitiy, Referb and Chorus Depht, Pan Pos, Volumen you only need to
enter CC Data Value.
Please note for e.f.g.: after you press enter key the LED display will show --- to indicate that
you pressed enter key and will not disappear until you press the MIDI SELECT knob to finish
your choice. After you press cancel key the LED display will show blank to indicate that you
pressed cancel key and will not disappear until you press the MIDI DSELECT knob to finish
your choice.
Program key
Pressing MIDI SELECT and then the Program key, then the numeric keys and then
the ENTER key, you can select any patch number between 1 to 127. For example, if
you want to change voice to 67 (Tenor Sax): Press the MIDI SELECT knob, the
program key and 67 on numeric keys, ENTER key and then MIDI SELECT again to
finish this action.
Assignment of the 17 Real-time Controllers
In order to assign a Controller Knob or Fader to a MIDI Parameter (MIDI Controller)
please follow these steps:
1. Press the MIDI SELECT knob and then SET CTRL (Controller) key (F3)
2. Choice number of knob on ten key groups (1 - 17) then press enter
8