Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION
Installing/Replacing the lens
With the delivery of the device you receive a second lens with which the beam angle can be changed.
Before changing or installing the lens unplug mains lead.
Procedure:
Step 1: Unscrew the ring for installing and changing the lens.
Step 2: Remove the lens that you want to change.
Step 3:.Insert the new lens with the textured side up front and tighten the ring.
Make sure that the ring is securely tightened to prevent accidental loosening.
Overhead rigging
Please consider the EN 60598-2-17and the respective national standards during the installation!
The installation must only be carried out by an authorized dealer!
The installation of the device has to be built and constructed in a way that it can hold 10 times the weight for
1 hour without any harming deformation.
The installation must always be secured with a secondary safety attachment, e.g. an appropriate catch net.
This secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
When rigging, derigging or servicing the device staying in the area below the installation place, on bridges,
under high working places and other endangered areas is forbidden.
(8) Power input
(9) Power output
(10) Display
(11) Enter button
8
(12) Down button
(13) Up button
9
(14) Menu button
10
(15) DMX output
(16) DMX input
11
12
13
14
15
16
DANGER TO LIFE!
22/32
00096817.DOC, Version 1.0
Werbung
Inhaltsverzeichnis
