Installation And Start-Up; Room Temperature - Vestfrost WFG32 Bedienungsanleitung

Installation and start-up.

Placement
For safety and operational reasons, the ap-
pliance must not be installed outdoors.
The appliance should be placed on a level
surface in a dry, well ventilated room (max.
75% relative air humidity). Never place the
appliance close to sources of heat such as
cookers or radiators, and avoid placing it in
direct sunlight.
Installation
The surface on which the appliance is to be
placed must be level. Do not use a frame
or similar. It is important that the appliance
be absolutely level. It can be levelled by
screwing the adjustable feet at the front of
the appliance up or down (fig. 2).
Use a spirit level to check that the appliance
is absolutely level sideways.
WFG32 is only for free-standing, and suf-
ficient free air around the appliance must be
ensured. (fig. 3)
The appliances WFG45 can be installed
as built-in units in kitchen elements or be
placed free-standing (fig. 4).
At built-in condition ensure sufficient airflow
through the kitchen base in front of the ap-
pliance. Individual air duct clearance must
be at least 5 mm.
WFG45: Along with your new cabinet is a
replaceable kick plate which can be fixed
with the two screws. These two screws are
located in the accessories
NOTE: The kick plate should not be in-
stalled if the unit installed behind a kitchen
shelf.

Room temperature

The climate class is stated on the rating
plate (see fig. 1 on page 4 and on page
12). This specifies the optimum room
temperature.
Climate
class
SN
N
ST
T
If needed there is a kit in the accessories
bag, for fixing the cabinet up against a table
top.
5
Optimum room tempera-
ture
+10 ºC to +32 ºC
+16 ºC to +32 ºC
+18 ºC to +38 ºC
+18 ºC to +43 ºC
fig. 2
fig. 2
GB