EINHELL HH 1200/1 Originalbetriebsanleitung Seite 11

Anleitung_HH_1200_1_SPK7__ 26.04.13 09:00 Seite 11
condensed water can damage the heater.
D
This equipment is not designed to be used by people
(including children) with limited physical, sensory or
mental capacities or those with no experience and/or
knowledge unless they are supervised by a person
who is responsible for their safety or they have
received instructions from such a person in how to
use the equipment safely. Children must always be
supervised in order to ensure that they do not play
with the equipment.
CAUTION
Read all the safety regulations and instructions.
Any errors made in following the safety information
and instructions set out below may result in an electric
shock, fire and/or serious injury.
Keep all safety information and instructions in a
safe place for future use.
2. Layout (Fig. 1)
1 Carry handle
2 Switch
3 Reflector
4 Heating elements
5 Supporting foot
6 Safety grille
3. Items supplied
Open the packaging and take out the equipment
n
with care.
Remove the packaging material and any
n
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
n
Inspect the equipment and accessories for
n
transport damage.
If possible, please keep the packaging until the
n
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
foils or small parts.
There is a danger of swallowing or suffocating!
Heater and supporting foot
n
Original operatings instruction
n
4. Intended use
The equipment can be used indoors in a free
standing position. Keep the equipment housing a
minimum distance of 1 m away from any walls and
combustible materials (furniture, curtains, etc.). The
equipment may only be used completely mounted
and standing vertically on a stable surface. It is
prohibited to operate the equipment on an instable
surface (e.g. on a bed).
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
equipment is used in commercial, trade or industrial
businesses or for equivalent purposes.
5. Technical data:
Rated voltage: 220-240 V ~ 50/60 Hz
Heat output:
Equipment dimensions incl. supporting foot,
approx.:
6. Before starting the equipment
6.1 Assembly
Guide the mains cable through the recess in the
n
middle of the supporting foot.
Fit the heater into the recess (Fig. 2).
n
Fasten the heater to the supporting foot with the
n
two thumb screws (1) (Fig. 3).
Feed the power cable (2) through the guides (3)
n
in the supporting foot to the outside as illustrated
(Fig. 3).
7. Using the equipment
Important. Before using the equipment for the first
time, check that the voltage supply is the same as the
voltage details set out on the rating plate. Read the
safety regulations in section 1.
When the equipment is used for the first time or after
a long period of rest, it may emit an odor for a short
time. This is not a fault.
GB
1200 W (3 x 400 W)
40 x 30 x 60 cm
11