AEG Electrolux SANTO Z 9 18 42-4 i Benutzerinformation Seite 37

Problem
The compressor operates
continually.
The compressor does not
start immediately after
pressing the FROSTMATIC
or TURBO COOLMATIC
button, or after changing
the temperature.
Temperature cannot be
set .
The temperature in the
appliance is too low/high.
The temperature in the
refrigerator is too high.
The temperature in the
freezer is too high.
There is too much frost.
Possible cause
The temperature is not set cor-
rectly.
The door is not closed correctly.
The door has been opened too
frequently.
The product temperature is too
high.
The room temperature is too
high.
This is normal, no error has oc-
curred.
FROSTMATIC or TURBO COOL-
MATIC functions switched on.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The product temperature is too
high.
Many products are stored at the
same time.
There is no cold air circulation in
the appliance.
Products are too near to each
other.
Food is not wrapped correctly.
The door is not closed correctly.
The temperature regulator is not
set correctly.
What to do if...
Solution
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open longer
than necessary.
Let the product temperature de-
crease to room temperature be-
fore storage.
Decrease the room temperature.
The compressor starts after a pe-
riod of time.
Switch off FROSTMATIC or TURBO
COOLMATIC manually, or wait to
set the temperature until the
function has reset automatically.
Refer to "FROSTMATIC or TURBO
COOLMATIC function"..
Set a higher/lower temperature.
Refer to "Closing the door".
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Make sure that there is cold air
circulation in the appliance.
Store products so that there is
cold air circulation.
Wrap the food correctly.
Refer to "Closing the door".
Set a higher temperature.
37