General View Of Application; Application; Coating Materials; Description Of Unit - Titan PowrCoat 630 Betriebsanleitung

2.

General view of application

2.1

Application

This spray system can be used for fine-finish as well as small
protective coatings applications.
Examples of objects to be sprayed
Metal finishing, concrete, wood finishing, cabinetry, exterior finishing.
2.2

Coating materials

Processible coating materials
Stains, latex, oil, acrylic, urethane and epoxy.
i
Pay attention to the spray quality of the coating
materials to be processed.
No other materials should be used for spraying without Titan's
approval.
Filtering
In spite of the high-pressure filter, filtering of the coating material
is to be recommended in general. Follow manufacturer's
recommendations regarding paint straining and mixing.
Stir coating material before commencement of work.
i Make sure when stirring with motor-driven agitators
that no air bubbles are stirred in. Air bubbles disturb
when spraying and can, in fact, lead to interruption
of operation.
Viscosity
This sprayer is not for high viscosity coatings or coatings that require
very high pressures for application. Recommended are light to
medium viscosity coatings with a manufacturer recommended
atomization pressure of 3000 PSI (207 bar) or less.
Two-component coating material
The appropriate processing time must be adhered to exactly. Within
this time rinse through and clean the unit meticulously with the
appropriate cleaning agents. This is acceptable for all coatings with a
pot life of 45 minutes or greater.
PowrCoat
GB
3.

Description of unit

3.1 Air Powered / Airless
An Airless piston pump takes in coating material by suction. The
pneumatic piston pump is powered by compressed air provided by
an outside air compressor (Air-Powered).
Cycling of the piston pump moves the material through the pump
and down the fluid hose to the spray gun. Pressed through the
tip at very high pressure, the coating material is atomized into fine
particles.
This method of spraying has the advantages of finest atomization,
cloudless operation and a smooth, bubble-free surface. As well as
these, the advantages of the speed of work and convenience must be
mentioned.
3.2

Functioning of the unit

The following section contains a brief description of the technical
construction for better understanding of the function.
TITAN PowrCoat are high-pressure spraying units driven by air power
provided by an air compressor.
An air compressor connected by an air hose drives the air motor (1)
which then moves the piston up and down in the material feed pump
(2), drawing up spray material via the siphon hose (3).
The air regulator (4) controls the air pressure being allowed into
the system, and is directly proportionate to the fluid pressure being
produced.
Example: PowrCoat 630 = 30:1
100 PSI reading at air gauge (5) = 3000 PSI at pump outlet
The inlet valve is opened automatically by the upwards movement
of the piston. The outlet valve is opened when the piston moves
downward.
Coating material flows under high pressure through the high-
pressure hose to the spray gun. When the coating material exits from
the tip it atomises.
1
5
2
5
General view of application
4
3