Operating The Appliance; Automatic Switch Off; Switching The Outer Rings On And Off; The Automatic Heat Up - AEG Electrolux HM634070MB Benutzerinformation

OptiHeat Control indicates the level of the residual heat.

OPERATING THE APPLIANCE

You operate the hob with the knobs of the appliance that you installed with the
hob. The Operating Instructions chapter for this appliance tells how to operate the
hob.
When a cooking zone operates, it hums for a short time. This is typical of all ceramic glass
cooking zones and does not show that the appliance operates incorrectly.

Automatic Switch Off

The function stops the hob automatically if:
• all cooking zones are off
• you cover a sensor field with an object (a pan, a cloth, etc.) for longer than 10 seconds.
The sound operates some time and the hob stops. Remove the object or clean the control
panel.
• you do not stop a cooking zone or change the heat setting. After some time
and the hob stops. See the table.
Automatic Switch Off times
Heat setting
Stops after
/

Switching the outer rings on and off

You can match the effective heating surface to the size of the cookware.
To switch on the outer ring touch the sensor field
more outer rings touch the same sensor field again. The next indicator comes on.
Do the procedure again to switch off the outer ring. The indicator goes out.

The automatic heat up

Automatic heat up function sets the highest heat setting for some time, and then decreases
to the necessary level. To switch it on turn the cooking zone knob to the right until you see
in the display. After that set the heat setting immediately.
11
10
9
8
7
6
5
4
3
2
1
0
1 2
.
, -
6 hours
3 4 5 6 7 8
-
5 hours
/
9
Operating the appliance
4 hours 1.5 hours
. The indicator comes on. For
21
comes on
-