Maintenance And Cleaning; Troubleshooting - Hazet 9033-2 Betriebsanleitung

USA

4. Maintenance and Cleaning

Oiling:
• Pneumatic tools have to be oiled throughout
their whole serviceable life. The motor and
the (ball) bearings need compressed air to
power the tool. As the moisture in the com-
pressed air leads to rust of the motor, daily
oiling of the motor is necessary. For this, the
use of an integrated oiler is recommended.
• HAZET 9070-1 Oiler can be fixed directly to
the pneumatic tool.
Oiling the pneumatic motor manually:
• Disconnect tool from the air supply and hold
with the air inlet showing upwards. Push
button and put 1 or 2 drops of special
pneumatic oil into the air inlet.
• Connect the tool to the air supply; cover the
air exit of the tool with a towel and
operate a few seconds.
• Never use combustible or easily evaporable
liquids, e.g. kerosene, petrol, diesel, etc. to
lubricate the tool.
ATTENTION!
Excess oil in the motor will be exhau-
sted immediately through the air
exhaust.
CAUTION!
Never point the air exhaust at any per-
son or at any object. The air exhaust is
at the rear side of the handle.
Maintenance:
• Before executing any maintenance work,
disconnect the appliance from the air
supply.
• If the tool is used daily, there should be
carried out an inspection after every three
month at the latest however after every
1,000 operating hours.
• All damaged or worn parts, such as
O-rings, bearings and blades must be repla-
ced. All moving parts must be oiled.
• Only use spare parts recommended by the
manufacturer, otherwise the warranty will be
void.
• When disposing of components, lubricants,
etc. please take care that the valid regu-
lations for environmental protection are
observed.
Always wear personal protective clothing and safety equipment!
Design and Function
• Do not use solvents or acids, esters (organic
compounds of acids and alcohol), acetone
(ketone), chlorinated hydrocarbons or nitro-
carbonic oils to clean the tool. Do not use
chemicals with a low flashing point.
• For after sales service please contact your
distributor/retailer.
4. Trouble Shooting
In case of malfunctions, please check
• the compressor installation and air hoses
(check whether the air consumption l/min
and the hose diameter correspond to the
technical specifications of the appliance);
• the compressed air in regard to the
occurence of dust, condensate and rust
particles;
• whether the air motor is oiled too much.
GB
21