Maintenance And Cleaning; Troubleshooting - Hazet PneumatischesMulti-Schleifer-Set 9033-6 Betriebsanleitung

GB
• Push throttle lever to operate the tool.
• Release throttle lever to stop tool operation.
• Be aware of the fact that the tool continues
moving for a while after the throttle lever has
been released.
• When the work is done, switch off com-
pressor and store it as indicated in its
operating instructions.
• Use clean and dry air at 90 PSI (6.2 bar)
maximum pressure only. Dust, combus-
tible steams and a too high moisture can
damage the motor of a pneumatic tool.
• Do not remove any stickers; replace
damaged stickers.
• Keep hands, wide clothing and long hair
away from the moving parts of the tool.

5. Maintenance and Cleaning

Oiling:
• Pneumatic tools have to be oiled throughout
their whole serviceable life. The motor and
the (ball) bearings need compressed air to
power the tool. As the moisture in the com-
pressed air leads to rust of the motor, daily
oiling of the motor is necessary. For this, the
use of an integrated oiler is recommended.
• HAZET 9070-1 Oiler can be fixed directly to
the pneumatic tool.
Oiling the pneumatic motor manually:
• Disconnect tool from the air supply and
hold with the air inlet showing upwards.
Push button and put 1 or 2 drops of special
pneumatic oil into the air inlet.
• Connect the tool to the air supply; cover
the air exit of the tool with a towel and
operate a few seconds.
• Never use combustible or easily evaporable
liquids, e.g. kerosene, petrol, diesel, etc. to
lubricate the tool.
Always wear personal protective clothing and safety equipment!
20
Design and Function
ATTENTION!
CAUTION!
Maintenance:
• Before executing any maintenance work,
disconnect the appliance from the air
supply.
• If the tool is used daily, there should be
carried out an inspection after every three
month at the latest however after every
1,000 operating hours.
• All damaged or worn parts, such as
O-rings, bearings etc. must be replaced. All
moving parts must be oiled.
• Only use spare parts recommended by the
manufacturer, otherwise the warranty will be
void.
• When disposing of components, lubricants,
etc. please take care that the valid regu-
lations for environmental protection are
observed.
• Do not use solvents or acids, esters (organic
compounds of acids and alcohol), acetone
(ketone), chlorinated hydrocarbons or nitro-
carbonic oils to clean the tool. Do not use
chemicals with a low flashing point.
• For after sales service please contact your
distributor/retailer.
6. Trouble Shooting
In case of malfunctions, please check:
• The compressor installation and air hoses
(check whether the air consumption l/min
and the hose diameter correspond to the
technical specifications of the appliance);
• The compressed air in regard to the
occurence of dust, condensate and rust
particles;
• Whether the air motor is oiled too much.
Excess oil in the motor will be
exhausted immediately through the
air exhaust.
Never point the air exhaust at any per-
son or at any object. The air exhaust is
at the rear side of the handle.
USA