Hazet 9033-2 Betriebsanleitung Seite 17

USA
• Do not point the tool at any person. Keep
children and other persons out of the work
area when operating the tool.
• Do not use the tool in no-load operation.
• Pneumatic tools must not get in contact
with sources of electricity.
• Pay attention to the working pressure,
(max. air pressure see table, page 18).
Exceeding the approved maximum pressure
of tools and accessories can cause explosi-
ons and may result in severe injuries. The
maximum pressure of the compressed air
must be equal or inferior to the approved
pressure load indicated for the air sander or
grinder.
• Check tight fit of the air hose connec-
tions/do not use defective pressure
hoses. Uncontrollably moving pressure
hoses may cause severe injuries.
• Only disconnect pneumatic tools in an
unpressurized state. Uncontrollably moving
pressure hoses may cause severe injuries.
• Use clean and dry air only. Never use
oxygen, carbon dioxid or other bottled gases
to power pneumatic tools.
• Only use parts, attachments and acces-
sories that are recommended by the
manufacturer.
• Never carry the tool by the air hose.
• Do not carry the connected tool with a
finger on the throttle lever.
• Avoid unintentional starting.
• Keep handles clean, dry and free of oil
and grease.
• Always keep the work area clean, well
ventilated and well lit.
• Do not use the tool under the influence of
alcohol or drugs.
• Any repairs must be carried out by autho-
rized persons only.
• The tool labelling must always be kept
legible. The operator/user is responsible
that the sticker indicating safety advice,
speed (r.p.m.), serial no. and article no. is
not damaged and well legible.
• Do not use quick-release couplings
directly at the tool. There must be a
pressure hose of at least 20 cm length
between the tool and the quick-release
coupling .
• Ensure air hose is disconnected when
Always wear personal protective clothing and safety equipment!
For Your Safety
changing grinding or sanding wheels,
discs or belts.
• Before oiling or changing grinding discs
etc. always disconnect the tool from the
compressed air supply. Read safety
instructions.
• Only use grinding/sanding wheels, discs
and belts which are approved and
allowed for the tool.
GB
17