Prior To Operation; Design And Function - Hazet 9033-2 Betriebsanleitung

USA

3. Prior to Operation

Pneumatic tools have to be used,
inspected and maintained always
in compliance with the respective
local, state, national or federal
regulations.
• Drain compressor tank and remove conden-
sation water from the air hoses. Read thou-
roughly through the operating instructions of
the compressor tank too.
IMPORTANT:
The use of an air filter and an air hose
oiler is recommended.
ATTENTION!
Before oiling, plugging in/out the
tool, disconnect the tool from the
compressed air supply.
• For oiling the tool, see chapter 4
"Maintenance and Cleaning" further on in
these operating instructions.
• Remove the dust cap at the air inlet.
• Connect the tool to a correctly sized air
hose.
See table on page 18
4. Operation
• Turn on the compressor to start the filling of
the air tank.
• Adjust the air compressor regulator to 90 PSI
(6.3 bar). The
pressure of this tool is 90 PSI (6.3 bar).
• The rotation performance may vary depen-
ding on the size of the air compressor and on
the output volume of compressed air.
• Do not use damaged, worn-out or low-
quality air hoses or connectors.
• The pressure for the adjustment of the
correct tool speed is either regulated by the
use of the compressor's regulator or by
mounting an extra pressure regulator.
• The speed is adjusted by the use of an air
inlet regulator (not included in delivery).
• The technical information given for this tool
refer to the use at 6.3 Bar.
• Always be cautious when working with
sanders or grinders. Careless working with
the tool might damage the inner parts
Always wear personal protective clothing and safety equipment!

Design and Function

maximum working
and/or the housing
grinding/sanding performance.
• Push throttle lever to operate the tool.
• Release throttle lever to stop tool operation.
• Be aware of the fact that the tool continues
moving for a while after the throttle lever has
been released.
• When the work is done, switch off com-
pressor and store it as indicated in its
operating instructions.
• Use clean and dry air at 90 PSI (6.3 bar)
maximum pressure only. Dust, combustible
steams and a too high moisture can
damage the motor of a pneumatic tool.
• Do not remove any stickers; replace
damaged stickers.
• Keep hands, wide clothing and long hair
away from the moving parts of the tool.
GB
reducing the
19