Klauke PK 45 Bedienungs- Und Wartungsanleitung Seite 8

Instruction manual PK 45
___________________________________________________________________________
2.) Insert the dies and bring the crimping head into position.
3.) Actuate the pump until the dies are completely closed.
The crimping process will proceed as described in chapter 4.2.
After the crimping process has been completed and the piston has been retracted remove
the connecting material from the crimping head.
5.2. Explanation of the application range
Our hydraulic crimping tool type PK 45 has a number of various dies
(Pos.-No. 2+3) available to crimp primarily copper and aluminium
connecting material.
Table 2
Crimping Crimping dies
range
mm²
120-1000 Compression cable lugs and joints
DIN 46235/DIN 46267
150-500 Aluminium cable lugs and
connectors
150-300 Compression joints for full-tension
connections Al-conductors acc. to
DIN 48201, sheet 5
A b b r e v i a t i o n s : Q S - C r o s s - s e c t i o n
Attention
Only crimp copper and Aluminium connecting material or special connecting
material which are mentioned in table 2.
If different conducting materials have to be crimped, please contact the manufacturer.
Attention
Do not use on or near live circuits.
Before starting to crimp please make sure that all parts involved in the crimping process
are not connected to live circuits.
The tool can be operated in a temperature range from -20°C to +40°C indoors and
outdoors.
Marking
outside profile
CU, „QS", code
DIN 46235 number
AL, „QS" code
number
Al, „QS" code
number
page 8
Picture 3
Surface of the
dies
chrome plated,
yellow
blue zinc
blue zinc