AEG MRC 4121 Bedienungsanleitung Seite 70

English
70
• In standby, keep the MEM.SET / NAP/MEM+ button (1) pressed for approx. 3 seconds.
A point next to (16) lights up. The display light turns off after approx. 15 seconds.
NOTE:
Press any button to switch on the brightness again for 15 seconds.
• Switch on the display light: To switch on the display light again permanently, press
any button briefly. Then keep MEM.SET / NAP/MEM+ button (1) pressed for approx.
3 seconds. The point next to (16) disappears.
Toggling the display
The following can be shown alternatingly on the display:
1. In order to activate this function, use the
2. Keep the / DISPLAY
Switch off toggling: To switch off Auto Toggle, keep the
again in standby. "
NOTE:
Only the time is shown via the rotatable projector (20).
Temperature display
There are two options for displaying the current room temperature:
• Briefly press the CLK.ADJ / TEMP button (5).
• Pass your hand over the Infrared sensors at a distance of 10 cm (21).
Toggle temperature display between °C (Celsius) and °F (Fahrenheit)
Press the / DST/C-F button (7) whilst the temperature is displayed.
Display after using the infrared sensors
The following indicators are shown on the display if you pass your hand repeatedly over
the infrared sensors in standby.
Temperature
The following indicators are shown on the display if you pass your hand repeatedly over
the infrared sensors when the device is in operation.
Radio frequency
Time Year Date
button (8) pressed, until "
" appears briefly on the display.
Alarm time AL1
Temperature Alarm time AL1
Temperature
button (9) to switch the device to standby.
" appears briefly on the display.
/ DISPLAY
Alarm time AL2
Alarm time AL2
button pressed
Time
Time