Regular Cleaning; Long-Term Absence; Trouble Shooting - AEG Electrolux A 75100GA3 Gebrauchsanleitung

For such purpose it is recommended to put all foods in the
baskets in the freezer compartment.

Regular cleaning

Never use soap or abrasives for cleaning.
Once is it disconnected from the mains, wash the product
with lukewarm water and then wipe it dry.
Use clean water to clean the door sealing gasket.
After the cleaning operations, reconnect the product to
the mains.
Once or twice a year it is recommended to remove the dust
and dirt from the condenser mounted on the back panel.

Long-term absence

If you do not use the product for longer periods, make sure
to perform the following:
Switch off the product by pressing the on/off switch until
the on/off indicator goes out.
Disconnect the product from the mains.
Remove all foods from the product.
Problem
Thermostat is set too low.
No sufficient pre-cooling done before freezing started.
Too large food inserted:
Cooling is too weak.
Too much food inserted for freezing at the same time.
Food inserted while still hot.
Door not fully closed.
Thermostat is set too high.
Cooling is too strong.
Plug is not properly inserted into socket.
No cooling at all.
No current in socket.
According to the indicator, the on/off switch (B) is not
switched on.
Noisy operation
Product support is not correct.
Inasmuch as the advice does not lead to result, call the nearest brand-mark service.
Power or operation failure:
In case of power failure during the storage of frozen foods, make sure not to open the freezer door. Once the power failure is
over, the yellow indicator (3) of the quick freeze function will light up and then, 5 hours after restart, it will automatically go
out.
If a short power failure occurs (max. 13 hours) and the product is full, the stored foods will not deteriorate. Otherwise you
must use the stored food as soon as possible (if the temperature of the frozen foods rises, their storability will be shorter).
When the electronic system fails to detect the ACTUAL temperature, the alarm indicator will start to flash. The product will
continue to operate with the use of a reserve system until the problem is eliminated by the local service personnel.
Perform defrosting and cleaning operations as described
above.
Leave the doors ajar to avoid the build-up of unpleasant
odors.

Trouble shooting

During operation of the appliance some smaller but
annoying trouble can often occur, which does not require
calling a technician out. In the following chart information
is given about them to avoid unnecessary charges on
service.
We draw your attention that operation of appliance goes
with certain sounds (compressor- and circulating sound).
This is not trouble, but means normal operation.
of compressor does not mean being no-current. That is
why you must not touch the electrical parts of the
appliance before removing it from the mains socket.
Possible causes
We draw it to your attention again that the
appliance operates discontinuously, so the stopping
Remedial action
Set to higher position.
Provide for sufficient pre-cooling time.
Cut food into pieces.
Insert less food.
Insert food of room temperature only.
Check if door is fully closed.
Set to lower position.
Check plug-socket connection.
Check presence of current.
Press the on/off switch (B) for more than a second.
Check stability of product support (all four feet
should stand on floor).
GB
39