Technical Data; Troubleshooting - EINHELL LE-HGG 110 Bedienungsanleitung

Anleitung HGG 110-300_SPK7

8. Technical Data

LE-HGG 110
HGG 110 Niro
Nominal heat load Qu: max. (Hi) 11,2 kW
Air throughput: 500 m 3 /h
Connection: G 30: 815 g/h
Equipment category: I3B/P
Type of gas: commercially
available propane
(DIN 51622)
commercially
available butane
(DIN 51622)
Operating pressure P: 300 mbar
Mains power supply: 230 V ~ 50 Hz 38 W
9. Trouble Shooting
Problem Cause
Motor doesn't start No electricity
Piezo doesn't ignite Electrode incorrectly adjusted
No gas at burner - Gas valve is closed
- Gas cylinder is empty
- Gas hose or connection leaks
Burner ignites, flame is - The thermoelement was not
extinguished as soon as the gas - warm enough
valve is released - The safety thermostat
- - switches off
Burner goes out while in use - Gas flow too high
- Air input too low
Important!
Have repairs carried out only by specialist workshops or ISC.
16.01.2006 12:47 Uhr
HGG 171 Niro HGG 300 Niro LE-HGG 110-CH
max. (Hi) 17 kW max. (Hi) 30 kW max. (Hi) 9,5 kW
500 m 3 /h 500 m 3 /h 500 m
G 30: 1430g/h G 31: 2150 g/h G 31: 815 g/h
I3B/P I3P I3P
commercially available commercially available commercially available
propane (DIN 51622) propane (DIN 51622) propane (DIN 51622)
commercially available
butane (DIN 51622)
300 mbar 1500 mbar 300 mbar
230 V ~ 50 Hz 38 W 230 V ~ 50 Hz 38 W 230 V ~ 50 Hz 38 W
Remedy
- Check electrical outlet
- Check mains cable
Check electrode and precisely
set according to diagram
- Open valve
- New gas cylinder
- Locate point of leak with soap
- foam and repair
- Repeat ignition procedure
- while pressing in the gas
- valve knob
- Allow the heater to cool for a
- few minutes and reignite
- Have the pressure regulator
- inspected and replace if
- necessary
- Check the suction grid and
- clean
- Inspect ventilator
Seite 11
GB
3 /h
11