Your Refrigerator Needs Air; Detaching The Worktop - AEG Electrolux S 64160 TK38 Gebrauchsanweisung

Your Refrigerator Needs Air

For correct operation this
appliance must be located in a
dry atmosphere, away from
heatsources,
radiators, boilers and direct
sunlight.
You should also ensure that air
can circulate freely around the
back and the top of the cabinet.
There should be 100mm (4")
between the top of the cabinet
and any overhanging kitchen
furniture.
Alternatively allow 50mm (2") between the top of the cabinet and any
overhanging kitchen furniture and a gap of 25mm (1") on either side of the
appliance.
If your refrigerator is installed
under a continuous worktop, an
air outlet opening of at least
200 cm
(A/B) matching the worktop
design should be installed at
the rear of the worktop. The cut
surfaces of the worktop (C)
should be varnished to avoid
swelling due to penetration of
moisture. The appliance wall
distance must beat least 30 mm
and should be checked before
the ventilation grille is inserted.

Detaching the Worktop

After the worktop has been
removed the appliance can be
installed underneath a continuous
worktop. The procedure is as
follows:
1.Unscrew the screws (1) on the right
and the left.
2. Lift the worktop slightly, push it
about 20 mm towards the rear, and
lift it off upwards (2). To remove the
top of the refrigerator unfasten the
screws on the front-right- and
front-left-hand side (3) and keep it
in a safe place (4).
34
e.g. cookers,
and a ventilation grille
2