Operation; Before Startup; Water Supply - Kärcher 1.671-xxx Betriebsanleitung

Operation

Description of the Appliance
When unpacking the product, make sure that no
accessories are missing and that none of the
package contents have been damaged. If you
detect any transport damages please contact
your dealer.
Illustrations on Page 2
1 High pressure connection
2 Suction hose for detergent
3 Appliance switch "0/OFF"/ „I/ON"
4 Storage for high-pressure hose
5 Carrying handle
6 Transport handle, adjustable height
7 Storage for spray lance
8 Storage for trigger gun
9 Mains cable with mains plug
10 Water connection
11 Bearing wheel
12 Coupling element for water connection
13 Trigger gun
14 Lock trigger gun
15 High pressure hose
16 Clamp for high pressure hose
17 Spray lance with dirt blaster
18 Spray lance with pressure regulation (Vario
Power)
Special accessories
Special accessories expand the possibilities of
using your appliance. Please contact your
Kärcher dealer for further information.

Before Startup

Illustrations on Page 2 - 3
Illustration
Pull out the clamp for the high-pressure hose
from the trigger gun (e.g. a small screwdriv-
er).
Illustration
Connect high pressure hose to trigger gun.
Push the clamp in until it locks. Check the se-
cure connection by pulling on the high-pres-
sure hose.
Illustration
Mount loose parts delivered with appliance
prior to start-up.
12
English

Water supply

According to the applicable regula-
tions, the appliance must never be
used on the drinking water net without
a system separator. Use a suitable
system separator manufactured by Kärcher; or,
as an alternative, a system separator as per EN
12729 Type BA.
Note: Impurities in the water can damage the
high-pressure pump and the accessories. For
protection, the use of the Kärcher water filter (op-
tional accessory, order no. 4.730-059) is recom-
mended.
Water supply from mains
Observe regulations of water supplier.
For connection values, see type plate/technical
data.
Use a fibre-reinforced water hose (not in-
cluded) with a standard coupling. (Minimum
diameter 1/2 inch (13 mm), minimum length
7.5 m).
Screw the coupling unit (supplied) to the wa-
ter connection on the appliance.
Push the water supply hose onto the cou-
pling unit, then connect it to the water supply.
Start up
Caution
Never operate the high-pressure cleaner when
the tap is turned off as dry running will damage
the high-pressure pump.
Connect the high pressure hose to the high
pressure connection of the appliance.
Push the spray lance into the trigger gun and
fasten it by turning it through 90°.
Completely open the water tap.
Insert the mains plug into the socket.
Turn on the appliance "I/ON".
Operation
Danger
The trigger gun is subjected to a recoil force
when the water jet is discharged. Make sure that
you have a firm footing and are also holding the
trigger gun and spray lance firmly.
Unlock the lever on the trigger gun.
Pull on the lever of the trigger gun; the device
will switch on.
Note: Release the lever of the trigger gun; the
device will switch off again. High pressure re-
mains in the system.