Adjustment Fail Safe; Connection From Transmitter To Receiver - Carson Reflex Wheel Pro LCD Betriebsanleitung

Adjustment Fail Safe

1. Set the throttle and the steering wheel to the
normal position.
2. Turn on the transmitter and receiver.
3. Press the F/S SET button, the LED on the receiver
should start flashing.
Reflex Wheel Pro:
As soon as the receiver/transmitter signal is inter-
rupted, the receiver switches to the default throttle
failsafe setting.

Connection from Transmitter to Receiver

1
1. Turn on the receiver power.
Press the SW switch. The
receiver's LED should start
flashing.
Attention
Keep the transmitter and receiver not over
40 cm apart when setting and binding.
CARSON Reflex Wheel Pro 50 050 0034 + 35 + 36 + 37
4. Put the throttle trigger at the brake position,
press the "F/S SET" button, the LED should
become solid.
5. For electric models, put the throttle trigger at the
stop position when you are making the failsafe
setting.
Reflex Wheel Pro2:
The Reflex Wheel Pro2 is fitted with the „Failsafe
pro +" system. This system also has integrated low
voltage protection. As soon as the voltage is too
low for safe operation, the receiver also switches to
the default throttle failsafe setting.
2
2. Turn on the
transmitter.
During the binding process
no other transmitter should be
operated in the vicinity at the
same time!
3
3. When the LED on the receiver
becomes solid, the binding
process is completed. The RC
system is ready.
GB
41