Safety Instructions - Carson Reflex Wheel Pro LCD Betriebsanleitung

Safety Instructions

R/C models can be dangerous and could cause
personal injury or damage to property. The appeal
of driving an RC model depends on assembling the
model accurately and operating it with due care
and attention.
1. Follow all the warnings, and instructions in this
manual.
2. Be „Safety Conscious" and use your common
sense at all times.
3. Remember that operating any R/C model
demands skills developed through proper
instruction and training – they are not acquired
immediately.
4. Don't run risks, such as operating your model in
adverse weather or when there is a malfunction
of which you are aware.
5. The remote control's special technology makes
the 2.4 GHz transmitter and receiver a single
unit and coordinates them together. Therefore,
the receiver is not influenced by any other
transmitter or radio signal.
It is no longer necessary to check whether
other models nearby are running on the same
frequency channel, as was the case with previous
frequencies (27/35/40 MHz).
6. Respect the rules of the R/C track on which you
operate your model.
Caution
Control of models is impossible with insufficient or
no voltage in the transmitter or receiver. A receiver
battery, that is too weak will move the servo(s) very
slowly, and that may cause erratic operation of your
model. When using a car that operates both the
CARSON Reflex Wheel Pro 50 050 0034 + 35 + 36 + 37
7. Running your model in the street is very
dangerous to both automobile drivers and your
model. Avoid running your model in the street.
8. Never aim or direct your model car at any person
or animal. These model cars accelerate very
quickly and can cause serious physical injury.
9. This remote control unit is not recommended for
operating model ships.
10. At any time during the operation of your model,
should you sense, feel, or observe any erratic
operation or abnormality, end your operation.
Do not operate it again until you are certain that
the problems have been fixed.
RC models are not "toys" – safety precautions
and forward thinking are essential when
operating a remote controlled model!
11. Take advantage of the failsafe setting. During
a breakdown in signal transmission (such was
when transmission voltage is too weak), this
setting shifts the model into a control mode that
prevents it from taking off uncontrolled.
Take your time to read all the way
through the pages of this booklet
before starting the installation.
electric motor and receiver on the same battery,
such as a BEC system, you should discontinue
operating the car, when the top speed becomes
sharply reduced, otherwise loss of control will result
soon afterwards.
GB
29