Trouble Shooting; E-Report In The Displays - Siemens ET475FUB1E Gebrauchsanleitung

3Trouble shooting

:
Warning – Risk of electric shock!
T r o u b l e s h o o t i n g
Incorrect repairs are dangerous. Repairs may only be
carried out by one of our trained after-sales engineers. If
the appliance is faulty, unplug the mains plug or switch
off the fuse in the fuse box. Contact the after-sales
service.
Display Error
None The power supply has been disconnected.
All displays flash The touch controls are wet or an object is rest-
ing on them.
The appliance has been grilling for a long time
"ƒ
at a high setting. To protect the electronics, the
front grill element has been switched off.
"... Despite the switch-off by
have become hot again. The appliance has
therefore been switched off.
The appliance was in operation for too long and
"‰
has switched itself off.
Demo mode is switched on
š" Appliance does not
heat up

E-report in the displays

When an error message with "E" appears in the display,
e.g. E0111, switch the appliance off and on again.
If it was a one-off error, the display goes out. If the error
message appears again, call the after-sales service and
quote the exact error message.
Faults often have simple explanations. Please read the
information in the table before calling the after-sales
service.
The electronics of your appliance are underneath the
control panel. For various reasons, the temperature in
this area may rise sharply.
So that the electronics do not overheat, the appliance is
automatically switched off as required.
displayed alternately with the residual heat indicator
or
Remedy
Check the household fuse for the appliance. Check whether there is a
power cut by trying other electronic appliances.
Dry the controls or remove the object.
Wait until the electronics have cooled down sufficiently. Touch any control.
"ƒ goes out.
Wait until the electronics have cooled down sufficiently. Touch any control.
"ƒ , the electronics
"...
goes out.
Switch the appliance on again.
Switch off demo mode: Disconnect the appliance from the power supply
for 30 seconds (switch off the household fuse or the circuit breaker in the
fuse box). Switch on the appliance. Touch any touch control in the next
3 minutes. Demo mode is switched off.
œ .
Trouble shooting
en
or is
"ƒ "...
•
29