Audible Alarm - PowerWalker VI 650 SH Kurzanleitung

6. Functions & Operation
I: DC Start Function
DC Start Function enables UPS to be started up when AC utility power is not available and battery is fully
charged. Just simply press the power switch to turn on the UPS.
II: AVR (Automatic Voltage Regulation)
If the quality of the incoming mains is poor, the AVR boosts a low incoming voltage or reduces a high one. The
load receives a voltage within the normal range.
III: Auto restart while AC recovery
IV: Audio Indicator

Audible Alarm

Sounding every 10 seconds
Sounding every 1 second
Sounding every 0.5 seconds
continuous sounding
V: HID Support (Human Interface Device)
 UPS supports communication with generic system drivers. User is able to control and monitor UPS basic
functions without WinPower installed. When UPS is connected to windows PC with USB cable, system will
show a battery icon located in the system tray, near the clock. You can get some basic information (ex.
Charging/Discharging, battery remaining capacity) by clicking the battery icon.
10
Situation
Battery Mode
Battery Low
Overload
Faulty
on charging status
on discharging status