VEGA VEGAPULS 68 Betriebsanleitung Seite 65

sensor_value
l
Raw sensor value, i.e. the uncalibrated measurement value from the sensor. Unit derives from
-
'Sensor_range.unit'
sensor_range
l
'Sensor_range.unit' refers to 'Sensor_value', 'Max/Min_peak_sensor_value', 'Cal_point_hi/lo'
-
simulate_primary_value
l
simulate_secondary_value_1
l
simulate_secondary_value_2
l
device_status
l
Linearization Type
l
Possible types of linearization are: linear, user defined, cylindrical lying container, spherical
-
container
curve_points_1_10
l
X and Y values for the user defined linearization curve
-
curve_points_11_20
l
X and Y values for the user defined linearization curve
-
curve_points_21_30
l
X and Y values for the user defined linearization curve
-
curve_points_31_33
l
X and Y values for the user defined linearization curve
-
curve status
l
Result of table plausibility check
-
SUB_DEVICE_NUMBER
l
SENSOR_ELEMENT_TYPE
l
display_source_selector
l
Selects the type of value, which is displayed on the indication and adjustment module
-
max_peak_sensor_value
l
Holds the maximum sensor value. Write access resets to current value. Unit derives from
-
'Sensor_range.unit'
min_peak_sensor_value
l
Holds the minimum sensor value. Write access resets to current value. Unit derives from
-
'Sensor_range.unit'
Calibration Highest Point
l
Min./max.-adjustment: Upper calibrated point of the sensor. It refers to 'Cal_level_hi'. The unit is
-
defined in 'Sensor_range.unit'
Calibration Lowest Point
l
Min./max.-adjustment: Lower calibrated point of the sensor. It refers to 'Cal_level_lo'. The unit is
-
defined in 'Sensor_range.unit'
cal_level_hi
l
Min./max-adjustment: Level at 'Cal_point_hi'. When writing 'Cal_level_hi' and 'Cal_type' = 1
-
(Online) the 'Cal_point_hi' is automatically set to the current sensor value. The unit is defined in
'Level_unit'
cal_level_lo
l
VEGAPULS 68 • Foundation Fieldbus
10 Anhang
65