Herunterladen Inhalt Inhalt Diese Seite drucken

Operation; Start The Engine; To Load The Generator; Storing The Engine - Parkside PSE 2800 A1 Betriebsanleitung

Vorschau ausblenden Andere Handbücher für PSE 2800 A1:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

... / ... / Cleaning, maintenance, storage, transport and ordering replacement parts

connector
of the generator (fig. C / Pos. 4)
4
and from the other side to an external ground.

Operation

ATTENTION! When being used for the first
time, motor oil (15 W-40, approx. 0.6 l) and petrol
(unleaded normal petrol) must be put in.
Check the fuel level and the oil, and if necessary
top them up.
Make sure you have adequate ventilation.
Ensure that the spark cable is securely in the
spark plug.
Unplug any electric device connected to the
generator.

Start the engine

ATTENTION! When starting with the express
start
you can injure your hand with the sudden
13
kick back.
Wear protective gloves when starting.
Open the petrol tap
wards.
Put the on / off switch
Turn the choke lever
position).
Start the engine with the express start
sharply pulling the handle. If the engine has not
started pull the handle again.
Push the choke lever
has started (in the right position).

To load the generator

Connect the device to the 230 V∼ socket
ATTENTION! This socket can be loaded con-
tinuously (S1) with 2600 W and short term (S2) for
a maximum of 2 minutes with 2800 W.
Note: Some electric devices (sabre saws, drills etc.)
can use more electricity when doing heavy duty tasks.
by turning the tap down-
14
to the on position.
11
to I Ø I (in the left
12
by
13
back once the engine
12
3

Storing the engine

Before putting away, let the generator run with-
out load so that the device can „cool down".
Turn the on / off switch
Close the petrol tap
Overload protection
2 x 230 V sockets
WARNING! This generator is fitted
with an overload protector.
This cuts off the sockets
load switch
the sockets
6
ATTENTION! If this happens reduce the
amount of electrical output which you are
extracting from the generator or remove
defective devices which are attached.
ATTENTION! Faulty overload switches
should only be replaced with identically
constructed overload switches with the
same performance data. Please use our
customer service department.
Cleaning, maintenance,
storage, transport and
ordering replacement parts
Before cleaning and maintenance work, turn off the
engine and pull the spark plug connector
the spark plug
28
ATTENTION! Turn the device off imme-
diately and contact your Service Station:
.
-
With unusual vibrations or noises.
-
If the engine seems overloaded or has backfired.

Cleaning

Keep the safeguards, air vents (fig. B / Pos. B1)
and the engine housing as dust and dirt free as
possible. Wipe the device with a clean cloth or
blow it with compressed air with low pressure.
to the „OFF" position.
11
.
14
. By activating the over-
3
can be used again.
3
.
GB/IE/CY
out of
29
9

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis