Connections; Cleaning And Maintenance; Technical Specifications - Omnitronic MPP-24 Bedienungsanleitung

The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.

Connections

Connect your audio mixer with the signal input sockets.
Connect your crossover or system controller with the signal output cables.
Connect the Speakon input cables with your amplifiers.
Connect your speaker-systems with the Speakon output sockets.

CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no serviceable parts inside the device. Maintenance and service operations are only to be carried
out by authorized dealers.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by authorized dealers only
in order to avoid hazards.
Should you have further questions, please contact your dealer.
The examination intervals for mobile electrical devices (German BGV A2) must be kept.
The operator has to make sure that the electrical devices are examined by an electrician before taking into
operation for the first time and after changes before taking into operation another time.
Electrical devices must only be taken into operation in a perfect condition and must be kept this way.
For keeping the perfect condition, electrical devices must repeatedly be approved in accordance with the
instructions given in the electro-technical guidelines.
A qualified electrician is responsible for the correct examinations.
Mobile electrical devices, extension cords with plugs, power cables with plugs and mobile cables with plugs
and permanent installation must be approved by an expert every three months.

TECHNICAL SPECIFICATIONS

Power supply:
Max. power output:
Max. total current:
Dimensions (WxHxD):
Weight:
Fuse:
Please note: Every information is subject to change without prior notice. 15.01.2009 ©
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
230 V AC, 50 Hz ~
3680 W
16 A
482 x 46 x 85 mm (19", 1 U)
1.5 kg
F 16 A, 250 V
14/14 00042743.DOC, Version 1.0