Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Frontpanel
MPP-24
Mini Patch Panel
T16A, 250V
AC POWER IN
FUSE
1
2
(1) Powercon input connector
(2) Circuit breaker
(3) Signal input sockets
(4) Link output sockets
(5) Speakon output sockets
Rearpanel
D
C
(6) Signal output cable
(7) Speakon input cable
(8) Powercon output socket
SETUP
Installation
Install the device on a plane surface or install it in rack.
Rack-installation: This device is built for 19" racks (483 mm). The rack you use should be a Double-Door-
Rack where you can open the frontpanel and the rear panel. The rack should be provided with a cooling fan.
When mounting the controller into the rack, please make sure that there is enough space around the device
so that the heated air can be passed on. Steady overheating will damage your device.
You can fix the controller with four screws M6 in the rack.
Please note that the maximum current of 16 A must never be exceeded.
Connect the device to the mains via the Powercon input connector. Connect the mains using a
Powercon/safety plug adapter cable.
Connection with the mains
Connect the device to the mains with the power plug.
The occupation of the connection cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green Earth
SIGNAL INPUTs
A
INPUT
B
A
LINK OUT
3
4
CABLE INPUTs
INPUTs
B
A
6
International
L
N
SPEAKON A/B/C/D
B
A
B
B
SIGNAL OUTPUTs
A
7
13/14
SPEAKON OUTPUTs
CABLE A/B/C/D
To Speakers
To Amplifiers
RED
CHA 1+
CHA
1-
BLACK
2+
2-
OUTPUTs
C
D
5
Type:
Power supply:
Power consumption: MAX. 3680W
AC POWER OUT
Fuse :
MAX.3680W
230VAC 50/60Hz
OMNITRONIC SHOWEQUIPMENT GmbH, GERMANY
8
00042743.DOC, Version 1.0
OMNITRONIC MPP-24
230 V AC, 50/60 Hz ~
T 16A, 250 V
Werbung
Inhaltsverzeichnis
