Master/Slave operation
The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR jack and an XLR plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
Press the MODE button to select the SLAu mode. The devices set in this manner can now be controlled by
the master unit.
Please see further instructions under Operation.
Connection with the mains
Connect the device to the mains with the enclosed power supply cable.
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Connection between devices
On the rear panel, there is an IEC socket (Power Out). Connect the output with the input of the next fixture
until all fixtures are connected.
Attention: It is recommended to renew the connection with the power mains after every 8 devices.
OPERATION
After you connected the EUROLITE LED SLS-144 RGBW Floor to the mains, the device starts running.
The LED display lights up and you can now choose the desired settings via the buttons MODE, ENTER, UP
and DOWN.
The device has two operating modes. It can be operated in stand-alone mode via the control board or the IR-
4 remote control or in DMX-controlled mode via any standard DMX controller.
Control board
MODE
UP
DOWN ENTER
STAND ALONE MODE
-
Setting Solid Colors
-
Internal Programs
-
Sound Control / Sensitivity
-
Master/Slave
-
Dimmer
-
DMX MODE
-
Addressing
-
4CH or 6CH selection
-
IR Remote Control
-
The control board offers several features, i.e. setting the DMX starting address,
running a preset program or selecting a DMX channel mode.
Browse through the menu by pressing MODE. You can change the selection by
pressing UP or DOWN. Press ENTER in order to confirm. You can leave every
mode by pressing MODE. The functions provided are listed in the following
sections.
20/24
00076701.DOC, Version 2.0