Cleaning And Maintenance - IKEA UNDERVERK Gebrauchsanleitung

ENGLISH
Cleaning and maintenance
WARNING: - Use safety gloves.
- Disconnect the appliance from the
power supply.
Never use steam cleaning equipment.- .
IMPORTANT: do not use corrosive or
abrasive detergents. If any of these products
accidentally comes into contact with the
appliance, clean immediately with a damp
cloth.
Clean the surfaces with a damp cloth. If it is
very dirty, add a few drops of washing up
detergent to the water. Finish off with a dry
cloth.
IMPORTANT: do not use abrasive sponges
or metallic scrapers or scourers. Over time,
these can ruin the surface.
Use detergents specifically designed for
cleaning the appliance and follow the
manufacturer instructions.
Perimeter suction panel
The suction panel must be cleaned with the
same frequency as the grease filter. Use a
damp cloth and a soft liquid detergent.
Do not use products containing abrasives.
DO NOT USE ALCOHOL
The panel normally covers the grease filters,
and must therefore be opened each time
access to the grease filters and the inside
of the hood is required (e.g. to replace the
carbon filters).
Opening: Pull the panel (LEFT SIDE for 60
cm hood or FRONT SIDE for 80 cm hood)
downwards.
Closing: The panels must be fixed to the
appropriate pins on the surface of the hood.
WARNING: Always check that the panel is
fitted properly.
To clean the grease filter
The metal grease filter has an unlimited life
and must be washed once a month by hand
or dishwasher at low temperature and with
a short cycle. With cleaning in a dishwasher
the grease filter may become dull; this does
not effect its filtering capacity.
8