Technical Data; Commissioning The Device; Risk Of Burns; Replacing The Wp 65 Soldering Tips - Weller WP 65 Betriebsanleitung

6-8
WARNING!
WARNING!

Technical data

4.2
Temperature range
Tool cable
Heating element
Temperature sensor
Heating output
Voltage (heater)
Heat-up time
Connection
Weight
Tip type
Supply unit

5 Commissioning the device

Risk of burns

The soldering tips of soldering irons become very hot during
soldering and desoldering processes.
There is a risk of burns from touching the tips.
 Do not touch the hot soldering tips and keep them away from
inflammable objects.
1. Carefully unpack the WP 65 soldering iron.
2. Place the soldering iron into safety rest WDH 10.
3. Insert the connecting plug (5) into the power supply socket and
lock it by turning it clockwise.
4. Check to make sure that the mains voltage matches the voltage
specified on the rating plate of the supply unit.
5. Switch on the supply unit and set the required temperature.
6. If the tool has not reached the required temperature. Wet the
soldering tip with solder.

6 Replacing the WP 65 soldering tips

Risk of burns
The soldering tip becomes hot during soldering and desoldering
processes.
There is a risk of burns from touching the soldering tip.
 The soldering tool must be switched off and stand at least
3 min. in the safety rest (WDH 10) until the soldering tip has
cooled off. Only replace the soldering tips when they are cold.
100°C - 450°C (212°F - 850°F)
Silicone rubber, heat resistant
Integrated heating wire element
Platinum sensor
65 W
24 V
(approx.) 7s (50°C to 380°C)
(120°F to 660°F)
6 pin connector, polarity protected with lock
30 g incl. cordless tip
XNT series
Weller stations
WP 65