Programming - IFM Electronic efector 500 PN3 Bedienungsanleitung

6. Programming

Take the following 3 steps for programming:
Press the "Mode/Enter"
1
button several times until the
respective parameter is
displayed.
Press the "Set" button for at
least 5s.
2 As soon as the display of the
parameter value is changed
the value can be increased*
(incremental by pressing briefly
or scrolling by holding pressed).
3
Press the "Mode/Enter"
button briefly.
*Decrease the value: Let the display of the parameter value move to the
maximum setting value. Then the cycle starts again at the minimum setting
value.
If no button is pressed for 20s during the setting procedure, the unit
returns to the operating mode.
Locking / Unlocking
The unit can be electronically locked to prevent unwanted adjustment
of the set parameters: Press both setting buttons for 10s. Indication
goes out briefly (acknowledgement of locking / unlocking). Units are
delivered from the factory in the unlocked state.
Select the parameter to be changed
Set the parameter value
Acknowledgement of the parameter value
Indication of the parameter
(here SP1).
After 5s the unit passes to the
programming mode, the value
increases continuously.
The set parameter value becomes
effective.
Wait 5s (then the unit passes to
the operating mode), or start
again with step 1 to program
other parameters.
19