Specifications; Specific Safety Rules; Functional Description - Makita TD0100 Betriebsanleitung

ENGLISH
1. Switch trigger
2. Reversing switch lever
3. Bit
4. Sleeve

SPECIFICATIONS

Capacities
No load speed (min
Impacts per minute (min
Max. fastening torque
Dimensions (L x W x H)
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Note: Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
............. Read instruction manual.
............. DOUBLE INSULATION
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.

SPECIFIC SAFETY RULES

DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to impact
driver safety rules. If you use this tool unsafely or
incorrectly, you can suffer serious personal injury.
1. Hold power tools by insulated gripping surfaces
when performing an operation where the cutting
tool may contact hidden wiring or its own cord.
Contact with a "live" wire will make exposed metal
parts of the tool "live" and shock the operator.
2. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
3. Hold the tool firmly.
4. Wear ear protectors.
4
Explanation of general view
5. Bit-piece
6. Standard bolt
7. Fastening torque
8. Fastening time (S)
Model
Machine screw
Standard bolt
High tensile bolt
-1
)
-1
)
Net weight
Safety class
SAVE THESE INSTRUCTIONS.
END201-4
WARNING:
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.

FUNCTIONAL DESCRIPTION

CAUTION:
ENF002-1
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on the
tool.
Switch action (Fig. 1)
CAUTION:
• Before plugging in the tool, always check to see that
the switch trigger actuates properly and returns to the
GEB012-2
"OFF" position when released.
To start the tool, simply pull the switch trigger. Tool speed
is increased by increasing pressure on the switch trigger.
Release the switch trigger to stop.
Holding the tool
When performing an operation. Do not touch the metal
part.
Reversing switch action (Fig. 2)
This tool has a reversing switch to change the direction of
rotation. Move the reversing switch lever to the
position (A side) for clockwise rotation or the
(B side) for counterclockwise rotation.
9. Proper fastening torque
10. High tensile bolt
11. Bumper
12. Hammer case cover
TD0100
4 mm - 8 mm
5 mm - 14 mm
5 mm - 10 mm
0 - 3,600
0 - 3,200
100 N•m
218 mm x 60 mm x 180 mm
0.96 kg
/II
position