Specifications - Makita DTW450 Betriebsanleitung

ENGLISH (Original instructions)
1. Red part
2. Button
3. Battery cartridge
4. Switch trigger
5. Lamp
6. Lamp switch
7. Socket

SPECIFICATIONS

Capacities
No load speed (min
Impacts per minute
Max. fastening torque
Overall length
Rated voltage
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for fastening bolts and nuts.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
CORDLESS IMPACT WRENCH
SAFETY WARNINGS
1. Hold power tool by insulated gripping surfaces,
when performing an operation where the fastener
may contact hidden wiring. Fasteners contacting a
"live" wire may make exposed metal parts of the
power tool "live" and could give the operator an
electric shock.
2. Wear ear protectors.
3. Check the socket carefully for wear, cracks or
damage before installation.
4. Hold the tool firmly.
5. Always be sure you have a firm footing. Be sure
no one is below when using the tool in high
locations.
4
Explanation of general view
8. Anvil
9. O-ring
10. Pin
11. Groove
12. Screw
13. Hook
14. Standrad bolt
Model
Standard bolt
High tensile bolt
Square drive
-1
)
Net weight
6. The proper fastening torque may differ depending
ENE036-1
upon the kind or size of the bolt. Check the torque
with a torque wrench.
SAVE THESE INSTRUCTIONS.
GEA010-1
WARNING:
DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to safety
rules for the subject product. MISUSE or failure to
follow the safety rules stated in this instruction
manual may cause serious personal injury.
IMPORTANT SAFETY
INSTRUCTIONS
FOR BATTERY CARTRIDGE
GEB049-2
1. Before using battery cartridge, read all
instructions and cautionary markings on (1)
battery charger, (2) battery, and (3) product using
battery.
2. Do not disassemble battery cartridge.
3. If operating time has become excessively shorter,
stop operating immediately. It may result in a risk
of overheating, possible burns and even an
explosion.
4. If electrolyte gets into your eyes, rinse them out
with clear water and seek medical attention right
away. It may result in loss of your eyesight.
5. Do not short the battery cartridge:
15. Fastening torque
16. Proper fastening torque
17. Fastening time (S)
18. High tensile bolt
19. Limit mark
20. Brush holder cap
21. Screwdriver
DTW450
M12 - M22
M12 - M16
12.7 mm
1,600
2,200
440 N·m
266 mm
3.4 kg
D.C.18 V
ENC007-4