Twist-Pad With Twist Knob; Removing Twist Knob; Storing The Twist Knob; Operation Without The Twist Knob - NEFF T16BT.6 series Gebrauchsanleitung

Vorschau ausblenden

Inhaltsverzeichnis

Verfügbare Sprachen

jTwist-Pad with Twist knob

The twistpad is the area in which you can use the twist

i s t k n o b

T w i s t - P a d w i t h T w

knob to select the hotplates and set heat settings. The

twist knob automatically centres itself in the twistpad

area.

The twist knob is magnetic and is placed on the

twistpad. Tapping the twist knob where there is a

marking activates the relevant hotplate. Turning the

twist knob selects the heat setting.

Note: Always keep the twist knob clean. Soiling may

impair its function.

Removing twist knob

You can remove the touch knob. This makes cleaning

easier.

You can also remove the twist knob while the hotplate

is on. The wipe protection function is activated and the

hob switches off after 35 seconds.

Notes

The main switch is excluded from the wipe

■

protection function. You can switch off the cooktop

at any time.

If you mount the twist knob again and then turn it, the

■

wipe protection function will be switched off.

Warning – Risk of fire!

If you place a metallic object onto the twistpad, the

cooktop may continue to heat up. Always switch off the

cooktop using the main switch for this reason.

Storing the twist knob

The twist knob contains a strong magnet. Keep the twist

knob away from magnetic data carriers, such as video

cassettes, diskettes, credit cards or cards with

magnetic strips. Otherwise they may be damaged

beyond repair. They can also cause interference in

television sets and monitors.

Warning – Hazard due to magnetism!

For wearers of electronic implants, e.g. pacemakers or

insulin pumps. Implants may be affected by magnetic

fields. You should therefore never carry the twist knob in

a pocket. They must be kept at least 10 cm from

pacemakers.

Note: The twist knob is magnetic. Metal particles which

stick to the underside can scratch the ceramic hob.

Always wipe the twist knob thoroughly.

Operation without the twist knob

If you have mislaid the twist knob, you can also operate

the hob without it:

Switch on the hob using the main switch.

Touch the

symbol and

seconds. An audible signal sounds.

Touch the

symbol repeatedly until the display for

the desired hotplate lights up.

Press the

(-) and (+)

setting required.

The hotplate is switched on.

Note: You can place the twist knob back on the

twistpad at any time.

1Operating the appliance

In this section, you can find out how to set the hotplates.

p l i a n c e

O p e r a t i n g t h e a p

The table shows heat settings and cooking times for

various meals.

Switching the hob on and off

The main switch is used to switch the hob on and off.

Switching on the appliance

Touch the

symbol. A signal sounds. The

above the main switch lights up. The control displays

and the heat setting displays

ready for use.

Switching off the appliance

Touch the

symbol until the

switch and the displays goes out. All hotplates are

switched off. The residual heat indicator remains on

until the hotplates have cooled down sufficiently.

Notes

The hob switches off automatically if all hotplates

■

have been switched off for longer than 20 seconds.

The settings remain stored for 4 seconds after the

■

hob has been switched off. If you switch it on again

during this time, the hob will operate using the

previously stored settings.

Setting a hotplate

Use the twist knob to set the desired cooking time.

Heat setting 1 = lowest setting

Heat setting 9 = highest setting

There is an intermediate setting between each heat

setting. This is identified by a dot.