A c c e s s o r i e s
Preparing the Base Tool for Straight and Right-Angle Swivel Head A t t a c h m e n t
•
Disconnect the air supply.
•
Remove any nose assembly items.
•
Remove Stem Collector Bottle Assembly 71210-20400 or 71213-05100 (see page 8 and 26).
•
Screw in place Safety Cap 71213-20201 or 71213-20102.
•
Unscrew Male 'T' Adaptor 40 and remove with 'O' Ring 11, Locknut 39, 'O' Rings 18 and 14, and Seal Housing 48. Do not refit
these items.
•
Screw Stop Nut (71213-20200) onto the front of Head Piston 35 as far as it will go by hand.
•
Fit Jaw Spreader Housing (71210-02101) and 'O' Ring 11, tighten onto Head Piston 35, finally tighten Stop Nut against Jaw
Spreader Housing.
The tool is now ready to be fitted with a swivel head. Instructions page 16.
Base Tool 71203
Base tool to receive a nose assembly
40 11 39
Base 71203 tool to receive a swivel head
71213-20200
STOP NUT
Base Tool 71204
Base tool to receive a nose assembly
40 11 39
Base 71204 tool to receive a swivel head
71213-20202
STOP NUT
Item numbers in bold refer to the general assembly drawing and parts list on pages 24-25.
48
18
14
48
18
14
35
71213-20102
SAFETY CAP
35
71210-20201
SAFETY CAP
15