A c c e s s o r i e s
S t e m D e f l e c t o r
The stem deflector is a very simple alternative to the standard stem collector and allows access in restricted areas. To replace the
stem collector with the stem deflector proceed as follows:
Preparing the Base Tool for use with Stem Deflector
The air line must be disconnected before any servicing or dismantling.
'Sealed Nut' 71213-02200 replaces Locknut 39 (to cut-off air supply to Vacuum System) as follows:
•
Loosen Locknut 39 using 16mm AF
Spanner.
•
Unscrew and remove both Male 'T'
Adaptor 40 and Locknut 39.
•
Replace Locknut 39 with 'Sealed Nut'
71213-02200, screw 'Sealed Nut'
onto Head Piston 35 to disable
Vacuum System.
•
Male 'T' Adaptor 40 must be
tightened onto Head Piston 35,
finally tightening 'Sealed Nut' against
it.
•
Remove the stem collector bottle
assembly (see page 8 and 26).
STEM DEFLECTOR
ADAPTOR
71213-20103
STEM DEFLECTOR 71213-20100
71203 Tool
•
Fit Stem Deflector (07340-00342) into Adaptor (71213-
20103).
•
Screw Adaptor onto End Cap Assembly 71403-05103.
•
Rotate the stem deflector until the aperture faces away
from the operator and any other person(s) in the vicinity.
E x t e n s i o n
Fitted between the tool and the nose assembly the extension allows
access into deep channels.
•
The Tool must be fitted with Jaw Spreader Housing 9* (71210-
02101) and 'O' Ring before extension (71210-20300). See
page 11 and 12.
•
To fit the extension, remove any nose assembly components.
•
Screw the Inner extension to Jaw Spreader Housing 9*.
•
Screw the Outer extension onto Head Assembly 50.
•
Fit the nose assembly onto the extension.
S w i v e l H e a d s
Instead of a nose assembly, a swivel head can be fitted to a base tool. It allows 360° rotation of the tool about the nose tip and allows
access into many applications otherwise too restrictive. There are two types of swivel heads: the straight swivel head with the nose tip
slightly offset from the centre line of the tool head and the right-angle swivel head with the nose tip on a perpendicular axis to the head
of the tool. See drawings on page 14 for dimensions and pages 15-16 for detail.
Item numbers in bold refer to the general assembly drawing and parts list on pages 24 and 25. 9* refers to illustrations on pages 11
and 12.
07340-00342
SEALED NUT
71213-02200
STEM DEFLECTOR
07340-00342
ADAPTOR NUT
71210-20101
STEM DEFLECTOR
71204 Tool
•
Fit Stem Deflector (07340-00342) into Adaptor (71210-
20101).
•
Screw Adaptor onto End Cap Assembly 71403-02102.
•
Rotate the stem deflector until the aperture faces away from
the operator and any other person(s) in the vicinity.
INNER
EXTENSION - 'T' ADAPTOR 71213-12000
EXTENSION - NON QUICK RELEASE 71210-20300
71213-20103
or
71210-20101
ADAPTOR
07340-00342
STEM DEFLECTOR
SEALED NUT
71213-02200
OUTER
13