Warning Symbols - Grundig GTN 48261 GC Bedienungsanleitung

Operating the product
Return to factory settings menu is used
to return the processes you have performed
back to the factory settings. Press spin
speed adjustment button in this menu.
Save Settings warning is displayed; when
the spin store adjustment button is
pressed again, factory settings are restored
and the display exits the menu to return to the
programme selection display.
The setting is saved by pressing and holding
for 3 seconds the menu access button and
then it exits the menu. User can operate the
machine by selecting the required programme.

5.9 Warning symbols

C
Warning symbols may differ
according to the model of your
machine.
Lint filter cleaning
When the programme is completed, a
warning symbol will appear to remind that the
filter needs to be cleaned.
C
If the Filter Cleaning symbol
is on continuously, refer to
"Troubleshooting" section.
Water tank
When the programme is completed, a
warning symbol will appear to remind that the
water tank needs to be drained.
If the water tank becomes full while the
programme is running, the warning symbol
will start to flash and machine will pause.
Drain the water in the water tank and
press Start / Pause button to resume the
programme. The warning symbol turns off and
the programme resumes operating.
56 / 68 EN
Cleaning the filter drawer
Warning symbol flashes with certain intervals
to remind that the filter drawer needs to be
cleaned.
Loading door open
Following warnings light alternately when the
loading door of the dryer is open.
Door is open
Program Paused
End Time Setting
End Time Setting function allows you to
delay the ending time of the programme up to
24 hours.
1. Open the loading door and put the
laundry in.
2. Select the drying programme, spin speed
and, if required, the auxiliary functions.
End Time
3. Press
to set the desired
Setting symbol lights up on the display.
(When the button is pressed and hold,
End Time proceeds uninterruptedly).
4. Press Start/Pause button. End Time
Setting starts to count down and End
Time enabled and Programme Started
labels appear on the display.The ":" in
the middle of the displayed End Time
Setting will start to flash.
Setting selection button
End Time
End Time.
Dryer / User Manuel