Ryobi EID-500RE Bedienungsanleitung Seite 11

GB
F D
OPERATING
NEVER COVER THE AIR VENTS (J) SINCE THEY MUST
ALWAYS BE OPEN FOR PROPER MOTOR COOLING.
DRILLING IN WOOD
To prevent ugly splits around the drill hole on the reverse
side of the workpiece, put a piece of scrap timber under
the work piece.
DRILLING IN METAL
Metals such as steel brass, aluminum sheets, stainless
steel, and pipe may also be drilled. Mark the point to be
drilled with a nail or punch.
Do not use impact mode on these materials.
DRILLING IN CONCRETE
Stone and masonry are generally drilled in the impact
drilling mode.
When drilling in delicate materials such as wall tiles,
it is essential to start with ordinary drilling and, once the
tile is pierced, to continue with impact drilling.
In deep bore holes the drill bit should be pulled out
occasionally in order to remove the debris from the
drill and hole.
AUXILIARY HANDLE AND STOPPER POLE
(FIG. 6)
Auxiliary handle
The auxiliary handle (H) can be rotated 360º.
Loosen the handle grip by turning in direction L,
and tighten it at an easy to-use position by turning
the grip in direction M.
Depth stopper
Holes of a fixed depth can be accurately bored by using
the depth stopper (G).
The depth of the hole will be the distance from the end
of the bit to the end of the stopper pole.
By turning the handle grip in direction L, the stopper pole
can be released and the depth adjusted. After adjusting
the depth, fix the stopper pole again by turning
the handle grip in direction M.
E I P NL S DK N FIN GR
English
BIT STORAGE (EID-750REN) (FIG. 7)
The auxiliary handle also contains a compartment to
store dill bits. To access this compartment unscrew
the end cap below the yellow trim on the handle in an
anticlockwise direction.
LIVE TOOL INDICATOR
This tool features a live tool indicator (K) which
illuminates as soon as the tool is connected to the
supply. This warns the user that the tool is connected
and will operate when the switch is pressed.
MAINTENANCE
After use, check the tool to make sure that it is in good
condition. It is recommended that you take this tool to
a RYOBI Authorized Service Center for a thorough
cleaning and lubrication at least once a year.
DO NOT MAKE ANY ADJUSTMENTS WHILE
THE MOTOR IS IN MOTION. ALWAYS DISCONNECT
THE POWER CORD FROM THE POWER SUPPLY
BEFORE CHANGING REMOVABLE OR CONSUMABLE
PARTS (BLADE, BIT, ETC.), LUBRICATING OR
WORKING ON THE UNIT.
SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE.
7
H CZ RUS RO
WARNING
To ensure safety and reliability, all repairs should
be performed by an AUTHORIZED SERVICE
CENTER or other QUALIFIED SERVICE
ORGANIZATION.
PL SLO HR TR