always fold in the bun warmer for storage to avoid damage to the wires. Thus, if
required, lift up the bun warmer lever to lower the bun warmer.
NOTES FOR DISPOSAL
Dispose of the appliance and packaging must be effected in accordance with the
corresponding local regulations and requirements for electrical appliances and
packaging. Please contact your local disposal company. Do not dispose of electrical
appliances as unsorted municipal waste, use separate collection facilities. Contact
your local government for information regarding the collection systems available.
If electrical appliances are disposed of in landfills, dumps, or refuse incineration,
hazardous substances can leak into the groundwater or can be emitted into air, thus
getting into the food chain, and damaging your health and well-being. When repla-
cing old appliances with new once, the retailer is legally obligated to take back your
old appliance for disposal at least for free of charge.
If you decide to dispose of the appliance, you should make the appliance inopera-
tive by cutting off the power cord to avoid hazards to children, who may play with
the appliance.
INFORMATION AND SERVICE
Please check www.gastroback.de for further information. For technical support,
please contact Gastroback Customer Care Center by phone: +49 (0)4165/22 25-0
or e-mail info@gastroback.de.
WARRANTY
We guarantee that all our products are free of defects at the time of purchase. Any
demonstrable manufacturing or material defects will be to the exclusion of any fur-
ther claim and within 2 years after purchasing the appliance free of charge repaired
or substituted. There is no Warranty claim of the purchaser if the damage or defect
of the appliance is caused by inappropriate treatment, over loading or installati-
on mistakes. The Warranty claim expires if there is any technical interference of a
third party without a written agreement. The purchaser has to present the sales slip
in assertion-of-claim and has to bear all charges of costs and risk of the transport.
34
2. Grasp the housing at both sides and place it in upright positi-
on on a suitable surface, where it cannot fall, and is out of
reach of young children
3. Lay the power cord loosely around the housing.
.