Technical Data; Declaration Of Conformity - Bosch GBM 13 Professional Originalbetriebsanleitung

16 | English

Technical Data

Rotary drill
Article number
Rated power input
Output power
No-load speed
Rated torque
Spindle collar dia.
Max. drilling dia.
– Steel
– Wood
– Aluminium
Chuck clamping range
Weight according to
EPTA-Procedure
01/2003
Protection class
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.

Declaration of Conformity

We declare under our sole responsibility that the
product described under "Technical Data" is in
conformity with the following standards or
standardization documents: EN 60745 according
to the provisions of the directives 2004/108/EC,
98/37/EC (until Dec. 28, 2009), 2006/42/EC
(from Dec. 29, 2009 on).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
03.08.2007, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
1 609 929 M60 | (11.9.07)
GBM 13
Professional
0 601 119 1..
W
W
rpm
Nm
mm
mm
mm
mm
1.5 – 13
mm
kg
Dr. Eckerhard Strötgen
Head of Product
Certification
Assembly
Auxiliary Handle (see figure A)
Operate your machine only with the auxiliary
handle 7.
900
The auxiliary handle 7 can be set to any position
for a secure and low-fatigue working posture.
475
Turn the bottom part of the auxiliary handle 7 in
950
counterclockwise direction and swivel the auxil-
30
iary handle 7 to the desired position. Then
43
retighten the bottom part of the auxiliary handle
7 by turning in clockwise direction.
13
Adjusting the Drilling Depth
32
The required drilling depth X can be set with the
20
depth stop 5.
Loosen the wing bolt for the depth stop adjust-
ment 6 and insert the depth stop rod into the
auxiliary handle 7.
2.5
Pull out the depth stop until the distance be-
/ II
tween the tip of the drill bit and the tip of the
depth stop correspond with the desired drilling
depth X.
Changing the Tool (see figure B)
Before any work on the machine itself, pull
the mains plug.
Wear protective gloves when changing the
tool. The drill chuck can become very hot dur-
ing longer work periods.
Open the key type drill chuck 1 by turning until
the tool can be inserted. Insert the tool.
Insert the chuck key 4 into the corresponding
holes of the key type drill chuck 1 and clamp the
tool uniformly.
Bosch Power Tools