Dynamic Range Control; Downmixing Mode; Dts Neo:6; Speaker Setting - Samsung BD-C6600 Bedienungsanleitung

HDMI
• If your TV is not compatible with compressed
multi-channel formats (Dolby Digital, DTS), the
product may output PCM 2ch downmixed
audio even though you set Bitstream(either Re-
encode or Audiophile) on your setup menu.
• If your TV is not compatible with PCM sampling
rates over 48kHz, the product may output
48kHz downsampled PCM audio even though
you set PCM Downsampling to Off.

Dynamic Range Control

You can listen at low volumes but still hear dialog
clearly.
This is only active when a Dolby Digital signal is
detected.
On : When Movie soundtracks are played at low
•
volume or from smaller speakers, the system
can apply appropriate compression to make
low-level content more intelligible and prevent
dramatic passages from getting too loud.
Off : You can enjoy the movie with the standard
•
Dynamic Range.

Downmixing Mode

Set whether to downmix the multi-channel audio
into fewer channels.
Normal Stereo : Downmixes the multi-channel
•
audio into two channel stereo. Choose when
connected to equipment that does not support
virtual surround functions such as Dolby Pro
Logic.
Surround Compatible : Downmixes multi-
•
channel audio into surround compatible stereo.
Choose when connected to equipment that
supports virtual surround functions such as
Dolby Pro Logic.

DTS Neo:6

You can enjoy multi-channel sound from a simple
2-channel audio source.
Off : Outputs a 2-channel audio signal through
•
the front speakers only.
Cinema : Select this if you want to play
•
2-channel movie sound over multi-channels.
Music : Select this if you want to play 2-channel
•
music sound over multi-channels.
NOTE
▪
If you are using HDMI receiver, this option is
available when you set Digital Output setup as PCM.
▪
You can use this option with analogue 7.1ch output
when you don't use HDMI receiver.

Speaker Setting

Set the speaker sound to obtain the best possible
surround sound.
This menu is available only when using 7.1ch
analogue output.
Settings
Display Speaker Setting
Audio
Front
System
Center
Network
Surround
Language
Surround Back :
Subwoofer
Security
Test Tone
General
< Change
Support
Set the front speaker size to Large.
Test Tone
A test tone will be sent to L
•
RSB LSB LS LFE in order, so you can
; ; ;
make sure the speakers are set up correctly.
• The test tone can only be activated when no
discs are in the unit.
• The test tone outputs through the 7.1 channel
analogue outputs only.
: Large
: Large
: Large
Large
: On
: Off
" Enter ' Return
C R RS
; ; ; ;

English