Setup
HDMI
•
If your TV is not compatible with compressed
multi-channel formats (Dolby Digital, DTS), the
product may output PCM 2ch downmixed
audio even though you set Bitstream(either Re-
encode or Audiophile) on your setup menu.
•
If your TV is not compatible with PCM sampling
rates over 48kHz, the product may output
48kHz downsampled PCM audio even though
you set PCM Downsampling to Off.
Dynamic Range Control
You can listen at low volumes but still hear dialog
clearly.
This is only active when a Dolby Digital signal is
detected.
Auto : The Dynamic Range Control will be set
•
automatically based on the information provided
by the Dolby TrueHD Soundtrack.
On : When Movie soundtracks are played at low
•
volume or from smaller speakers, the system
can apply appropriate compression to make
low-level content more intelligible and prevent
dramatic passages from getting too loud.
Off : You can enjoy the movie with the standard
•
Dynamic Range.
Downmixing Mode
Set whether to downmix the multi-channel audio
into fewer channels.
Normal Stereo : Downmixes the multi-channel
•
audio into two channel stereo. Choose when
connected to equipment that does not support
virtual surround functions such as Dolby Pro
Logic.
Surround Compatible : Downmixes multi-
•
channel audio into surround compatible stereo.
Choose when connected to equipment that
supports virtual surround functions such as
Dolby Pro Logic.
DTS Neo:6
You can enjoy multi-channel sound from a simple
2-channel audio source.
Off : Outputs a 2-channel audio signal through
•
the front speakers only.
English
Cinema : Select this if you want to play
•
2-channel movie sound over multi-channels.
Music : Select this if you want to play 2-channel
•
music sound over multi-channels.
NOTE
▪
If you are using HDMI receiver, this option is
available when you set Digital Output setup as PCM.
▪
You can use this option with analogue 7.1ch output
when you don't use HDMI receiver.
Speaker Setting
Set the speaker sound to obtain the best possible
surround sound.
This menu is available only when using 7.1ch
analogue output.
Settings
Display
Speaker Setting
Audio
System
Network
Language
Security
General
< Change
Support
Test Tone
A test tone will be sent to L
•
RSB
LSB
LS
;
;
;
make sure the speakers are set up correctly.
•
The test tone can only be activated when no
discs are in the unit.
•
The test tone outputs through the 7.1 channel
analogue outputs only.
Front
:
Large
Center
:
Large
Surround
:
Large
Surround Back :
Large
Subwoofer
:
On
Test Tone
:
Off
" Enter
' Return
C
R
RS
;
;
;
LFE in order, so you can
;