Wired Network - Samsung BD-C6600 Bedienungsanleitung

Setup

Wired Network

1.
In the Network Settings menu, press the ▲▼
buttons to select Network Settings, and then
press the ENTER button.
The Internet Protocol Setup screen appears.
2. Press the ► button, then select Auto or
Manual, and then press the ENTER button.
Setting Up a Wired Connection - Auto
1. If you selected Auto, the Network Function
acquires and fills in the values for IP Address,
Subnet Mask, etc., automatically.
NOTE
▪
This process can take up to five minutes.
Settings
Network Settings
Display
Internet Protocol Setup : Auto
Audio
IP Address
System
Subnet Mask
Network
Gateway
Language
DNS
Security
DNS Server
General
Support
> Move
2.
After the Network Function has acquired the
network values, press the RETURN button.
Then, run a Network Test to ensure the
product has connected to your network (See
page 41).
3.
If the Network Function does not acquire the
network values or you selected Manual, go to
the directions for Manual Setup.

English
\
: 0 0 0 0
: 0 0 0 0
: 0 0 0 0
: Auto
: 0 0 0 0
" Select ' Return
Setting Up a Wired Connection - Manual
If the Auto Setting does not work, you'll need to
set the Network Setting values manually.
To get the Network setting values from most
Windows computers, follow these steps:
1.
Right click the Network icon on the bottom
right of the screen.
2.
In the pop-up menu, click Status.
3.
On the dialog that appears, click the Support
tab.
4.
On the Support tab, click the Details button.
The Network settings are displayed.
To enter the Network settings into your product,
follow these steps:
1.
On the Internet Protocol Setup screen, press
the ENTER button.
2. Press the ▲▼ buttons to select Manual, and
then press the ENTER button.
3.
Press the ▼ button to go to the first entry field
(IP Address).
Settings
Network Settings
Display
Internet Protocol Setup : Manual
Audio
IP Address
System
Subnet Mask
Network
Gateway
Language
DNS
Security
DNS Server
General
Support
> Move
Select to configure your network type and IP address, or to perform a Network Test.
4.
Use the number buttons on your remote to
enter numbers.
5.
When done with each field, use the ► button
to move successively to the next field.
You can also use the other arrow buttons to
move up, down, and back.
6. Enter the IP Address, Subnet Mask, and
Gateway values.
7. Press the ▼ button to go to DNS.
8.
Press the ▼ button to go to the first DNS
entry field. Enter the numbers as above.
\
: 0 0 0 0
: 255 255 255 0
: 0 0 0 0
: Manual
: 0 0 0 0
" Select ' Return