Safety Instructions - Victron energy BlueSolar MPPT 150/70 Anleitung

2. SAFETY INSTRUCTIONS

Danger of explosion from sparking
Danger of electric shock
It is advised to read this manual carefully before the product is installed and put into use.
This product is designed and tested in accordance with international standards. The
equipment should be used for the designated application only.
Install the product in a heatproof environment. Ensure therefore that there are no
chemicals, plastic parts, curtains or other textiles, etc. in the immediate vicinity of the
equipment.
Ensure that the equipment is used under the correct operating conditions. Never operate
it in a wet or dusty environment.
Never use the product at sites where gas or dust explosions could occur.
Ensure that there is always sufficient free space around the product for ventilation.
Refer to the specifications provided by the manufacturer of the battery to ensure that the
battery is suitable for use with this product. The battery manufacturer's safety instructions
should always be observed.
Protect the solar modules from incident light during installation, e.g. cover them.
Never touch uninsulated cable ends.
Use insulated tools only.
At a voltage >75 V, particularly with regard to the open circuit voltage of the PV array, the
solar system must be installed according to protection class II. A chassis grounding point is
located on the outside of the product. If it can be assumed that the grounding protection is
damaged, the product should be taken out of operation and prevented from accidentally
being put into operation again; contact qualified maintenance personnel.
Ensure that the connection cables are provided with fuses or circuit breakers. Never
replace a protective device by a component of a different type. Refer to the manual for the
correct part.
Connections must always be made in the sequence described in section 4
4