Pioneer SGY-PM900H79 Benutzerhandbuch Seite 8

EN
Installing and Removing the Batteries/Switching Modes
Left transmitter
•
• When putting in new batteries for the
first time, look at the switches in the
battery compartment and make sure
the sensor mode is set to the mode
you want to use.
• The transmitters' device numbers
are printed on the inside of the
covers. Use the device numbers to
pair the sensors with the Pioneer
Cyclocomputer SGX-CA900. Refer
to the Installation Manual for details.
8
3. Switch the sensor mode.
Change the sensor mode by using the
slide switch in the battery compartment
while the batteries are removed.
• Right transmitter
• Left transmitter
Pedaling: pedaling mode
ANT+: power meter mode
• Set the left and right sensors to the
same mode.
• For use with Pioneer's SGX-CA900,
set the sensor mode to "Pedaling".
For use with other cyclocomputer
brands, set the sensor mode to
"ANT+".